Stinson is a model intended for beginner pilots. However, due to its ability to use all four primary controls, it is also suitable for the more advanced modellers. With a more powerful motor the model is able to execute also the quite demanding and complicated aerobatic figures of today's routines.

The take-off and landing on the tricycle undercarriage is an excellent for fun and training for flying with the bigger models.

The nimbleness and the low minimum speed as well as the excellent durability and toughness enable to fly the model in quite confined spaces.

What you will need

• The RC set:

• Transmitter                           four-channel, eventually only three-channel

• Servos 4x                             e.g. HS-55 (9 g) rudder, elevator, 2 x ailerons

• Receiver                               Jeti Rex 5 MPD (10 g)

• Motor                                     AC, weight of 40-60 g (e.g. AXI-2208/26)

• Controller                             AC, min. 18A current (Jeti Advance 18A)

• Propeller                               e.g. APC E 8/6

• Accumulator battery           LiPol, 2-3 cells of 800-1500 mAh, (80 -120 g)

• A list of other necessary material: epoxy glue, medium-thick cyanoacrylate glue (a well proven brand is Flash), battery connectors. 

• A list of necessary tools: modelling knife, soldering iron, snippers.

Power plants roster, as tested in real life

• Motor                                     Axi 2208/26

• Controller                             Jeti Advance 18A

• Propeller                               APC E 8/6

• Accumulators                      2x LiPol 800mAh

• Accumulators                      3x LiPol 800mAh

• Motor                                                 Axi 2212/26

• Controller                                         Jeti Advance 18A

• Propeller                                           APC E 8/6

• Accumulators                                  2x LiPol 1350mAh

A list of parts in the kit:   

• 1 x wing of the EPP

• 2 x wing spar (1,5 x 500 mm)

• 1 x rubber (900 mm)

• 2 x aileron control rod

• 1 x wing reinforcement (strip 3 x 10 x 60 mm)

• 1 x wing reinforcement (plastic 0,5 x 60 x 25 mm)

• 1 x EPP fuselage

• 1 x fuselage former

• 1 x cockpit hood former

• 2 x wing attachment dowel (3 x 70mm)

• 2 x strip - wing attachment dowel stop (strip 3 x 10 x 40 mm)

• 1 x motor bearer

• 1 x undercarriage base plate (wood??)   překližka??

• 1 x undercarriage base plate (glassfibre)

• 1 x undercarriage

• 1 x nose undercarriage leg

• 3 x wheel 35/14/2

• 2 x control rood 730 mm  (rudder, elevator)

• 2 x bowden 490 mm  (rudder, elevator)

• 1 x horizontal tail of EPP

• 1 x horizontal tail stiffener (2 x 8 x 80 mm strip)

• 1 x vertical tail of EPP

• 4 x control horns

• 1 x securing of the control rods (tube)

• 1 x wheel securing (tube)